ANALYSIS of A 23-GAUGE ULTRA HIGH-SPEED CUTTER WITH DUTY CYCLE CONTROL
Nenhuma Miniatura disponível
Data
2013-05-01
Autores
Diniz, Bruno [UNIFESP]
Fernandes, Rodrigo B. [UNIFESP]
Ribeiro, Ramiro M.
Lue, Jaw-Chyng
Teixeira, Anderson G. [UNIFESP]
Magalhaes, Octaviano [UNIFESP]
Maia, Mauricio [UNIFESP]
Humayun, Mark S.
Orientadores
Tipo
Artigo
Título da Revista
ISSN da Revista
Título de Volume
Resumo
Purpose: the purpose of the study was to determine the performance of dual pneumatic ultra high-speed 23-gauge cutters operated with variable duty cycle (DC) settings.Methods: Frame-by-frame analysis of high-speed video was used to determine the DC in core, 50-50, and shave modes. Using three cutters at various cycles per minute and aspiration levels, mass of water or vitreous removed from a vial was measured within a specified time period. Average flow rates were calculated for each aspiration level and cut rate with the different DC options.Results: the DC increased with increasing cut rate in the shave mode was relatively stable in the 50-50 mode and decreased for the core mode. the DC converged at 5,000 cycles per minute for the 3 different modes. Water flow curves followed the DC variation. Vitreous flow rates for all the DC modes increased with increasing cut rates and peaked at 5,000 cycles per minute (P < 0.05). the results of the 50-50 mode, which had isolated the DC influence, showed that increasing aspiration and/or cut rate independently increased the vitreous flow rate.Conclusion: Progressive values of aspiration and/or cut rate increase the vitreous flow rate, independently of the DC. the DC control also has an important effect on the vitreous flow, but this effect was reduced at high cut rates because of convergence of the DC modes. RETINA 33: 933-938, 2013
Descrição
Citação
Retina-the Journal of Retinal and Vitreous Diseases. Philadelphia: Lippincott Williams & Wilkins, v. 33, n. 5, p. 933-938, 2013.